
Indentation test to characterise environmental effects on the porcine iris anterior and posterior surfaces
The purpose of this ex vivo study was to determine the overall mechanical behavior of a porcine iris sample by varying the testing environment and temperature - using the Mach-1 micromechanical tester. Knowing such information can guide towards understanding the optimal testing conditions that will allow researchers to investigate the influence of abnormal iris morphology on specific ocular disorders. It is well known that testing by indentation results in more sensitive tissue properties near the indenter than to those further away from the indenter (local properties). Therefore, indentation tests were performed on both anterior and posterior surfaces of the porcine iris.
A sample was prepared by manual dissection, bisected and tested for three different environments and two different temperatures: hydrated with drops of room-temperature (RT) phosphate-buffered saline (PBS), submerged in RT PBS, and submerged in 37°C PBS. A cyanoacrylate adhesive was used to bind the anterior and posterior surfaces to a 25.4 mm flat indenter in order to keep the samples leveled and gripped for the indentation test. The mechanical testing was performed using a 1.0 mm diameter flat indenter installed on a 1.5 N load cell (75uN resolution). Each anterior and posterior surface of the iris was indented at three different locations (n=3) using the following parameters: loading to 0.0015 N using a velocity of 0.005 mm/s and 180 sec hold at this position.
A Biomomentum Mach-1 v500css micromechanical tester was used to extract the thickness, indentation modulus (using the Hayes Model for a flat-punch indenter), relaxation time, and percentage of load lost for each sample under the different testing conditions (hydrated with PBS drops at RT, submerged in PBS at RT and at 37°C). The results indicate that submerging the samples in solution and increasing the temperature of the PBS causes the samples to swell.
Comparing data from the samples hydrated with RT drops to submerged in RT PBS, the thickness increased by 4% for anterior and 9% for posterior after submersion; the modulus decreased by 11% for anterior and 22% for posterior. Then, comparing submerged RT PBS with submerge 37°C PBS, the thickness increased by 5% for both surfaces after heating; the modulus decreased by 6% for anterior and 16% for posterior. The reductions in modulus could be influenced by the increase in thickness of the sample and, thus, a reduced effect of the underlying stiff cyanoacrylate adhesive layer.
A decrease in relaxation time (time from peak load to 37% of total loss during stress relaxation) and a decrease of the percent load loss was seen when the samples were submerged in PBS and heated. This effect could be poroelastic in nature as submerging the samples in PBS minimizes their interstitial fluid loss during compression which allows them to maintain the internal fluid pressure between tissue fibers. In other words, submerging the sample could create a greater pressure gradient that pushed the fluid back into the tissue more quickly and the increased pressure lead to a higher equilibrium pressure or load after relaxation.
This study highlights that the mechanical properties of porcine iris could be a function of different environmental conditions such as hydration and temperature. In the future, the Mach-1 could be used to examine different indenter shapes (spherical, flat-punch), sizes (0.3mm-5mm) and locations (full mapping of sample surface). Other gripping methods such as clamping should be investigated as well to minimize the effect of the underlying stiff cyanoacrylate adhesive used to secure the samples.
Figures

Figure 1 — Show caption
Indentation locations identified on the anterior and posterior surfaces of a porcine iris.

Figure 2 — Show caption
Photographs of the posterior and anterior surfaces of the porcine iris.

Figure 3 — Show caption
Iris thickness, elastic modulus and relaxation measurements under different PBS hydration and temperature conditions.











